Akai GX-77

Timed Playback
Before beginning:
@ Prepare the timer and make all necessary connections. Connect the e@ Set the TAPE SELECTOR for the tape to be played.
Power Cord. @ Set the TAPE SPEED selector to the speed at which the recording fe
@ Check the timer is set to the correct time. was made.
1. Set the timer to EVER ON or ON. 5. Depress the stop button ( mm) to re-
* There are differences between the timers on the market so please lease playback.
refer to the timer’s operator's manual for the correct procedure
for your timer.
2. Switch on the power to the deck and
other components connected to the OUTPUT
timer and prepare for playback. See
page 7,
Adjust the volume from the speakers.
6. Set the TIMER START selector on -
this deck to PLAY.
REC OFF PLAY
ap All ae
3. Set the REV SELECTOR.
REV
selec Ton CoM
— «s SC
7. Set the timer start time and the length of playing time and then set
the timer to AUTO or TIMER the deck and other components will
be turned off.
. 8. The deck is now ready for timed playback.
4. When playback is to begin in forward
direction, press the forward button
{ ™ ) and check the tape is travelling
forwards.
* If playback is to begin from the
reverse direction, press the reverse
button (~ ) and check the tape
is travelling in the reverse direc-
tion.
Power Cord zi
BB 0000 C000 00 00000000000 ta
Power Cord
RIGHT LINE OUT RIGHT PLAY
J |
LEFT LINE OUT LEFT PLAY SBS ee ee /
bs 10000 nont ©)
Pre/Main
Amplifiers
[2] Power Cord
|
= |
|
Speaker
15