Akai GX-F44R

1. SPECIFICATIONS
TRACK SYSTEM 4 Track 2 Channel Stereo System
TAPE Philips Type Cassette
TAPE SPEED 4.76 cm/s + 1.5% (1-7/8 ips. + 1.5%)
HEADS Twin Field Super GX head for recording/playback x 1
Erase head x 2
MOTORS Electronically speed controlled
D.C. motor for capstan drive x 1
D.C. motor for reel drive x 1
WOW & FLUTTER Less than 0.035% WRMS, 0.11% (DIN 45 500)
TAPE WINDING TIME 80 sec. using a C-60 cassette tape
FREQUENCY RESPONSE Normal: 25 to 16,000 Hz + 3 dB (~20 VU)
CrO,: 25 to 17,000 Hz + 3 dB (-20 VU)
25 to 9,000 Hz + 3 dB (0 VU)
Metal: 25 to 19,000 Hz + 3 dB (-20 VU)
25 to 13,000 Hz + 3 dB (0 VU)
SIGNAL TO NOISE RATIO Normal: Better than 58 dB
CrO,: Better than 60 dB
Metal: Better than 60 dB
(measured via tape with peak recording level)
Dolby B NR ON: Improves up to 5 dB at 1 kHz, 10 dB above 5 kHz
Dolby C NR ON: Improves up to 15 dB at 500 Hz, 20 dB at 1 to 10 kHz
HARMONIC DISTORTION Normal: Less than 0.8%
CrO,: Less than 0.7%
Metal: Less than 0.7%
INPUT MIC: 0.25 mV (input impedance 5.0 kohms)
Required microphone impedance: 600 ohms
Line: 70 mV (input impedance 47 kohms)
OUTPUT Line: 410 mV at 0 VU
Required load impedance: more than 20 kohms
Phone: 1.3 mW/8 ohms at 0 VU
DIN Input: 2.0 mV (input impedance 10 kohms)
Output: 410 mV
Required load impedance: more than 20 kohms
POWER CONSUMPTION 34W
POWER REQUIREMENTS 100V, 50/60 Hz for Japan
120V, 60 Hz for USA and Canada
220V, 50 Hz for Europe except UK
240V, 50 Hz for UK and Australia
110V/120V/220V/240V, 50/60 Hz switchable for other countries
440(W) x 118(H) x 309(D) mm_= (17.3 x 4.7 x 12.2”)
8.6 kg (19.0 Ibs)
DIMENSIONS
WEIGHT
* For improvement purposes, specifications and design are subject to change without notice.
*
“Dolby”
and
the
Double
D
symbol
are
trademarks
of
Dolby
Laboratories.
(Manufactured
under
license
from
Dolby
Lavoratories.)