Akai GX-F44R

V. VOLTAGE AND CYCLE CONVERSION
POWER SUPPLY PCB REAR PANEL
SHORT PIN
Fig.4 Voltage Conversion (U/T Model only)
1. VOLTAGE CONVERSION
Models for Canada, Europe, USA, UK, Australia and
Japan are not equipped with this facility.
Each machine is preset at the factory according to
destination, but some machines can be set to 110V,
120V, 220V or 240V as required.
If voltage change is necessary, this can be accom-
plished as follows:
1) Disconnect power cord.
2) Loosen holding screws and remove upper cover.
3) Remove short pin plug from present holes and
replace in correct holes. Follow the markings
explicitly.
2. CYCLE CONVERSION
With DC motor, cycle conversion is not necessary.