Akai GXC-570D

V. MECHANISM
ADJUSTMENT
CAPSTAN SHAFT
PLAY SOLENOID
PLUNGER SLI
FLYWHEEL
(RIGHT }
ORIVE BELT
FIXATION NUT
ROTOR PLATE
FIXATION SCREW
MOTOR PULLEY
FS SSS SENS SOOT SHS SOTNNN NOT
ORIVE BELT
N MOTOR
CAPSTA
sc
Fig. 8
FIXATION SCREW
REEL TABLE
REEL MOTOR SHAFT
Fig. 9
FLYWHEEL
(LEFT)
CAPSTAN MOTOR SCM- 700
ADJUSTMENT SCREW Fig. 7
1. CAPSTAN SHAFT LOOSE PLAY
ADJUSTMENT (Refer to Fig. 7)
Adjust by turning adjustment screws to obtain a
0.1 mm degree of loose play (space indicated by
* mark in Fig. 7) when the capstan shaft is moved as
indicated by the arrow mark. Tighten fixation nut to
maintain optimum adjusted condition.
2. MOTOR PULLEY INSTALLATION
POSITION ADJUSTMENT (Refer to Fig. 8)
Tighten fixation screw at position at which the parts
indicated by the * mark in Fig. 8 makes contact with
the rotor plate.
NOTE: After above adjustment, in case the drive
belt does not run on the center of Motor
Pulley, re-adjust installation position of
Motor Pulley so that the drive belt comes to
the center of the Pulley.
3. REEL TABLE INSTALLATION POSITION
ADJUSTMENT (Refer to Fig. 9)
As shown in Fig. 9, with reel table firmly and com-
pletely fitted on motor shaft, tighten fixation screw.
eomn
dy.
i tte
—_