Akai GXC-570D

RELEASE LEVER
: EJECT KEY
a
EJECT MICROSWITCH Sw8&
MECHA FRAME
Fig. 13
FIXATION SCREW
RECORDING MICROSWITCH SW3
CASSETTE MICROSWITCH SW6
FIXATION SCREW
Fig. 14
6. ADJUSTMENT OF EJECT MICRO SWITCH
ACTUATING POSITION (Refer to Fig. 13)
Adjust by bending Eject Key so that when the Eject
Key is depressed, Eject Micro Switch (SW8) shown in
Fig.13 is perfectly actuated. After adjustment,
depress Eject Button and confirm that Eject Micro
Switch (SW8) switches before the Release Lever
operates.
7. ADJ USTMENT OF RECORDING MICRO |
SWITCH (SW3) AND CASSETTE MICRO
SWITCH (SW6) ACTUATING POSITION
(Refer to Fig. 14)
Move M Switch Plate A as indicated by the arrow
marks in the figure and adjust so that when the parts
of Recording and Detection Levers marked with
* mark in Fig. 14 are at a horizontal level, Recording
Micro Switch (SW3) and Cassette Micro Switch (SW6)
are turned ON respectively. Further, confirm that
when a cassette from which the recording safety tabs
have been removed is loaded, Recording Micro Switch
(SW3) switches, and when the cassette is removed,
Cassette Micro Switch (SW6) switches. Tighten
fixation screws to maintain ideally adjusted positions
of M Switch Plates A.
16