Akai GXC-570D

FIXATION SCREW
ROTARY MAGNET
TAPE COUNTER
FIXATION SCREW
STOP DETECTION PC BOARD
CB- 2026
Fig. 19
18
"EJECT GUIDE
tesa =e
FRONT PANEL
ee ay
Fig. 18 Left Side of the Deck
10. POSITION ADJUSTMENT OF LID CASE
(Refer to Fig. 18)
Move the Eject Guide shown in Fig. 18 (direction
indicated by arrow mark) up and down and adjust
Lid Case so that it is even with the front panel. If
the upper part of Lid Case comes too far inward, raise
the eject guide, and if too far outward, lower eject
guide.
11. CLEARANCE ADJUSTMENT BETWEEN
HALL a AND ROTARY MAGNET
(Refer to Fig, 19)
This adjustment is necessary for the perfection of the
Automatic Stop Function. If adjustment is necessary
due to poor Automatic Stop Function or instability,
proceed as follows:
1) As shown in Fig. 19, move Stop Detection P.C.
Board as indicated by the arrow ‘mark in the
figure, and adjust position so that the clearance
between the HALL IC and rotary magnet is 1 mm.
2) In case this clearance is over 1 mm, faulty Auto-
matic Stop Function will occur.
wy Ore