Akai GXC-570D

|. TECHNICAL DATA
TRACK SYSTEM
4 track 2 channel stereo system
TAPE Philips type cassette
TAPE SPEED 1-7/8 ips (Pitch Control +5%) =e
WOW AND FLUTTER Less than 0.06% WRMS
Less than 0.17% (DIN 45500)
FREQUENCY RESPONSE
. 30 Hz to 19,000 Hz (+3 dB) using Fe-Cr tape -
30 Hz to 15,000 Hz (+3 dB) using low noise tape
30 Hz to 16,000 Hz (+3 dB) using C,O, tape
DISTORTION Less than 1% (1,000 Hz “0” VU) using low noise tape
SIGNAL-TO-NOISE RATIO Better than 52 dB (measured via tape with peak recording level of +5 VU)
Dolby Switch ON: Improves up to 10 dB above 5 kHz g
ERASE RATIO Better than 70 dB ‘
BIAS FREQUENCY 100 kHz :
HEADS GX recording/playback head and erase head (3 head system)
MOTORS One AC Servo outer rotor motor for capstan drive and two DC motors
for reel drive
FAST FORWARD AND REWIND TIME 60 to 80 seconds (variable) using 4 C-60 cassette tape
OUTPUT JACKS Line (2): 0.775V (0” VU)
Required load impedance: More than 20 k ohms’
Phono (1): 50 mV/8 ohms ies.
INPUT JACKS = Microphone (2): 0.3 mV
ae Required microphone impedance: 600@’ohms -
Line (2): 70 mV/100 k ohms
TRANSISTOR 2SA628 (E) (F) .....-....--- 3 -
2SB605 (K) (L) ..........:-. 2
2SC458LG (C) ..... Waites: ahah ate 8
2SC945L (P) (Q) (R).-.--. ee 75
2SC1175 (E) (F) -....-.-+.-- 3
2SC1211 (E) (F) ...-. 6.6666. 1
28C1222 (E) (F) .....-.----. 4
2SC1647 (S) (E) ............ 6
2SC1683 (P) (Q) ............ 1 gses
2SD360 (D) (E) .........-.. 1
2SD361 (D) (E) (D1) ........ 2
2SD401 (K) (L) .....-...6.- 1
2SD571 (K) (L) (M)...... bad
FET 2SK30A (D) (GR) ....-...--5 10
2SK68A (L) (M) ...........- 2
IC wPCLO23H..............-..- 2
wPC10O24H.... 0... eee 4
TATL22AP posit ata ee 8 2
DN835) 2 2. eee eee esis 1
DIODE ENB 4 Aire oi. eens ane Meter eee 8
18247330 ei et ee es 59
IS2473VE «5 eee-o ed sere eae 88
LOD 2S te ee aes pa 4
MODS i. 2 eee AAS Se os 1
LODS tes canted seat ePned ". 6
7 WZ085 ....... 02 cee eee 2
WZ 240» iio cia Decale pirat ae 2
POWER REQUIREMENTS
CSA, UL and LA Models: 120V, 60 Hz only
CEE Models: 220V, 50 Hz only
Other Models: 100V to 240V, 50/60 Hz, (switchable)
DIMENSIONS
WEIGHT .
440(W) x 255(H) x 225(D) mm
(17.3 x 10.0 x 8.9")
13.5 kg (28.5 Ibs)
NOTES: 1. For improvement purposes, specifications and design are subject to change without notice.
2. Noise reduction circuit made under license from Dolby Laboratories Inc.
The word ‘DOLBY’ and the Double-D symbol are trademarks of Dolby Laboratories Inc.