MPC1000 v2 Operator’s Manual rev 1.0
60
Chapter 11: Editing a sample
Dividing a sample into regions of equal length
01. In the Sample field within the TRIM page, select a sample you wish to edit.
You can set the sample range you wish to edit by adjusting the start/ end point.
For more information about adjusting the start/end point, see “Adjusting the start point” and “Adjusting the end
point” section on page 53.
02. Press the [F5] (SLICE) key.
The SLICE window will be displayed.
Number of Region (2 - 64) : You set the number of regions you wish to divide the sample into.
03. Press the [F5] (DO IT).
The MPC1000 will start dividing the sample, and then go to the “SLICE” page.
The next step is to adjust the divided regions.
The MPC1000 will divide a sample into seperate regions of equal length. You choose the number of sections.
To Next Page
Loading...
