V.
VOLTAGE
CONVERSION
(a) Bottom View
Models for Canada, USA, Australia, Japan and Europe
are
not
equipped with this facility.
This machine can
be
set to
11
0V, 120V, 220V or 240V
as
required. Each machine
is
preset at the factory
according to destination. However,
if
voltage change
is
necessary, this can be accomplished
as
follows:
I.
Disconnect power cord.
2. Loosen holding screws and remove bottom and upper
cover.
3.
Turn
the voltage selector until the arrow points to the
correct voltage for your area with a minus screw-
driver.
4. Change the fuse (FU903):
Tl
.6A for 1
lOV
to 120V
and T630 mA for 220V to
240V.
20
PRE
AMP
POWER
SUPPLY
P.C
BOARD
72-1871
(b) Top View
Fig. 4 Voltage Conversion
•
•
To Next Page
Loading...
