Akai UC-K2

I. TECHNICAL DATA
FM TUNER SECTION
FREQUENCY RANGE
SENSITIVITY (IHF)
CAPTURE RATIO
SELECTIVITY (IHF)
IMAGE REJECTION
IF REJECTION
SPERIOUS REJECTION
AM SUPPRESSION
SIGNAL TO NOISE RA TIO
HARMONIC DISTORTION
FM FREQUENCY RESPONSE
MUTING
STEREO SEPARATION
PILOT SIGNAL SUPPRESSION
SUB CARRIER SUPPRESSION
OUTPUT VOLTAGE
ANTENNA INPUT IMPEDANCE
AM TUNER SECTION
FREQUENCY RANGE
SENSITIVITY (IHF)
SELECTIVITY (IHF)
IMAGE REJECTION
IF REJECTION
SIGNAL TO NOISE RATIO
OUTPUT VOLTAGE
ANTENNA
MISCELLENEOUS
SEMICONDUCTORS
POWER REQUIREMENTS
POWER CONSUMPTION
DIMENSIONS
WEIGHT
88 MHz to 108 MHz
76 MHz to
90 MHz (Japan only)
1.9 µV
More than 1.5 dB
More than 55 dB
More than 50 dB
More than 85 dB
More than 60 dB
50 dB
67 dB
MONO:
Less than 0.15% (100% modulation)
STEREO:
Less than 0.3% (100% modulation)
20 Hz to 15,000 Hz +l dB, -1 dB
Switchable to ON - OFF
More than 40 dB ( 1 kHz)
More than 55 dB
More than 55 dB
1 V (100% modulation)
300 ohms balanced. 75 ohms unbalanced
525 kHz to 1,605 kHz
250 µV/m (Bar Antenna)
More than 30 dB
More than 40 dB
More than 35 dB
More than 40 dB
0.3 V (30% modulation)
Built in ferrite bar antenna
Transistors: 4, Diodes: 21, ICs: 10,
LEDs: 8, FETs: 1
lO0V, 50/60 Hz for Japan
120V, 60 Hz for USA and Canada
220V, 50 Hz for Europe except UK
240V, 50 Hz for UK and Australia
11 0/l 20/220/240V. 50/60 Hz internally switchable for other
countries
12W for JPN, CSA. AAL, U/T Models
280(W) x 56(H) x 303(D) mm (11.0 x 2.2 x 11.9) inches
3.0 kg (6.6 lbs)
* For improvement purposes, specifications and design are subject to change without notice.
4
t)
0)