V.
VOLTAGE
CONVERSION
Models for Canada, USA, Australia, Japan and Europe
are
not
equipped with this facility.
This machine can be set
to
11
OV,
120V, 220V or 240V
as
required. Each machine is preset at the factory
according
to
destination. However,
if
voltage change
is
necessary, this can be accomplished by a qualified
service personnel
as
follows:
1.
Disconnect power cord.
2. Loosen holding screws and remove upper cover.
3. With a flat bladed screwdriver rotate the selector,
located
on the left hand side (Power Switch side),
until the arrow points
to
the desired voltage.
34
•
Fig. 4 Voltage Conversion
To Next Page
Loading...
