V.
VOLTAGE
CONVERSION
Models for Canada, USA, Australia, Japan and Europe
are
not
equipped with this facility. This machine can be
set
to
110V, 120V, 220V or 240V
as
required. Each
machine
is
preset at the factory according to destination.
However,
if
voltage change
is
necessary, this can be
accomplished
by
a qualified service personnel
as
follows:
1.
Disconnect power cord.
2. Loosen holding_screws and remove top panel.
3. With a flat bladed screwdriver rotate the selector,
located on the left hand side (Power Switch side),
until
the arrow points to the desired voltage.
8
FRONT
..ilfllll'I'
Fig.
3 Voltage Conversion (U/T Model)
To Next Page
Loading...
