Operating Manual JUPITER 100J & 150J 7 (28)
JUPITER 800/900 100J & 150J Document-ID: 948681-000
Version: A2 Author: SH
EN
MULTI-OPERATOR OPERATION
Multi-operator operation means that two transmitters can operate the same
object. This can be benecial, for example, when the view is blocked. The
control of the object can be passed between two transmitters. Active crane se-
lection and deselection guarantees that only one transmitter is in control of the
object at a time. The layout and function of the transmitter for multi-driver op-
eration is different from the standard described in this manual. See separately
documentation supplied with the transmitter for multi-operator operation.
DUPLEX (150JD only)
In a duplex system the transmitter gets information from the receiver and
shows it on the display, for example weight.
See ”Display indications (150JD only)” on page 9.
AUTOMATIC SWITCH-OFF FUNCTION
The transmitter is equipped with an automatic switch-off function, switching
off transmitter after 2, 5, or 15 minutes after the latest use. It is also possible to
set the transmitter for continuous drive. The status indicator for operation goes
out and the main contactor is deactivated upon automatic switch-off. See the
installation manual for instruction how to set the automatic switch-off time.
This setting shall be done by authorized and qualied personnel only.
For renewed activation of the main contactor a restart is required, press down
the STOP button, pull out the STOP button again and press the button.
The transmitter is now operational.
Low battery voltage also causes automatic switch-off.
To Next Page
Loading...
Need help?
General
