AKO AKO-D14545 - Parameter Setup; Programming Menu

D145H4502 Ed. 01
18
Parameter setup
Through the programming menu users can set different parameters to adjust the operation of the controller to the
needs of their installation.
Programming Menu
It allows changing the unit’s operating parameters.
To access the programming menu, press the SET button for 10 seconds, or until the “PRG” appears on the screen.
IMPORTANT: If the password function has been configured, the system will demand entering the
password programmed in L5. If the entered password is not correct, the unit will go back to showing
the temperature.
After 20 seconds with no key being pressed, the equipment will return to the previous level. If you are on level 3,
the changes will not be saved.
ESC
ESCESC
OK
OKOK
OK
OK
SET
SET
SET
SET
SET
SET
OUT OF
PROGRAMMING
PROGRAMMING
20 sec.
Temperature
Indication
Level 1
Menus
Level 2
Parameters
Level 3
Values
Change
value
Change
parameter
Save changes
Don’t save changes
Change
menu
20 sec.
20 sec.
10 sec.