AKO AKO-D14545 - Limits and Default Values of the Pressure and Temperature Parameters According to Units

D145H4502 Ed. 01
23
Limits and default values of the pressure and temperature parameters accor-
ding to units.
The following table shows the default values and the limits of the pressure and temperature parameters according to
the display units defined by parameter C09 during quick start (See page 5).
MINIMUM DEFAULT value MAXIMUM
Pressure Temp. Pressure Temp. Pressure Temp.
bar ºC bar ºC bar ºC
E01 E03 5 5 E02
E02 E03 65 99.9 65 99.9
E03 -0.7 -50 -0.7 -50 E02
E06 0.0 2 2 50 50
E08 -0.7 -50 0.1 -30 * *
F01 F03 14 32 F02
F02 F03 65 99.9 65 99.9
F03 -0.7 -50 -0.7 -50 F02
F06 0.0 2 2 50 50
F10 N.A. -50 N.A. 28 N.A. 99.9
F11 N.A. 6 N.A. 12 N.A. 20
P03 -60 -50 -1 -50 65 300
P04 -60 -50 9 300 65 300
P05 -20 -20 0 20 20
P06 -60 -50 0 -50 65 300
P07 -60 -50 34 300 65 300
P08 -20 -20 0 20 20
P09 N.A. -20 N.A. 0 N.A. 20
I11 -20 -20 0 20 20
A03 -0.7 -50 0 -40 65 99.9
A04 0.1 0.1 1 1 20 20
A05 -0.7 -50 20 45 65 99.9
A06 0.1 0.1 1 1 20 20
* Depending on the compressor control type: Proportional=E01; Neutral zone=E01-E06.