Care of the engine
Air filter
Spark plug
Oil change
Drain used oil when the motor is warm. Warm
oil drains quickly and completely.
To collect oil, place a suitable container under the engine.1.
Remove the oil dipstick.2.
Screw in the filler neck.3.
Push the beam downwards and tilt the equipment, until 4.
the beam touches the floor. Drain the oil completely.
Pull the equipment up and fill with oil (SAE 10W-30, 5.
quantity: 0,25l)
Remove the filler neck.6.
Screw in the oil dipstick.7.
Dispose of used engine oil in a manner that is
compatible with the environment!
We recommend to collect the used oil in a
closed container and to deliver it to a suitable
recycling or service station.
Used oil should not be
disposed of with domestic rubbish
poured into the sewage water system or
drain pipes
poured on the ground
Observe the operating instructions supplied by the en-
gine manufacturer.
Storage
Caution!
Do not store motor near open flames or heating
sources - Burn and/or explosion danger!
Let the engine cool down.
Store the scarifier in a dry place.
To save storage space, unscrew the butterfly nuts
on the beam and fold it in.
Faults and remedies
Fault Remedy
The engine
does not start
Fill up with petrol
Pull the control bar towards
the handle.
Check the spark plugs and
replace if necessary.
Clear the air filter.
Set a lower cutting height.
The roller does
not turn
See a service station
Engine power
reduced
Set a lower cutting height.
Replace the worn blades.
Mow the lawn (the grass is
too high).
Poor scarifier
performance
Set a lower cutting height.
Replace the worn blades.
Rough run-
ning
Strong vi-
brations
Damaged blades.
See a service station.
Faults that cannot be rectified with the aid of this table
must be eliminated by an authorised workshop only.
To Next Page
Loading...
