Aladdin IND600 - Introduction; Specifications

IND600 Heat On Demand
®
ULTRA SYSTEM
Installation Operation
& Service Manual
FOR PARTS & SERVICE CALL 1 (800) 888-5426
6
I. INTRODUCTION
The Aladdin Temp-Rite Heat On Demand
®
Ultra Heat Activator is designed to provide a quick clean and
efcient heat source for use with the Aladdin Temp-Rite Heat On Demand
®
Ultra base.
The activator has been specically created for use ONLY with Aladdin Temp-Rite's Heat On Demand
®
Ultra
bases. There is no exposed coil open ame or heated surface. The only heat applied to the top surface of
the base is that which is absorbed from internal component base parts.
This activator contains no operator serviceable parts. Please consult a qualied electrician or the Aladdin
Temp-Rite Service Department should the equipment require service. Aladdin's toll free service line is
1-800-888-5426.
This product contains micro processor based componentry.
Potential voltages on the ground line or unstable electrical circuits may adversely affect the
operation of this equipment due to high frequency harmonics generated. Reliable grounding
practices prior to installation should be made to ensure line noise is minimized.
II. SPECIFICATIONS
MODEL NUMBER IND600
LENGTH 18.9”
WIDTH 17.6 ”
HEIGHT 13.4”
VOLTAGE (with isolated ground) 208-240VAC
FREQUENCY 50/60HZ
PHASE 3
MAX AMPS DRAW 15
MINIMUM AMP CAPACITY 20
NEMA PLUG L15 -20P
WEIGHT 39 lbs
NUMBER OF WIRES 4
RECEPTACLE TYPE L15 -20R
i
! WARNING !
This equipment is to be installed only by a qualied electrician. There are
no operator serviceable parts inside this activator. Operators should never
remove the back panel or fuse access panel of this activator.