FOR PARTS & SERVICE CALL 1 (800) 888-5426
9
the situation.
B. CONCEALED DAMAGE- (All claims should be reported within 10 business days)
Any receiving operation should inspect for this type of damage.
IF PRODUCT IS DAMAGED
1. Receiver should hold the shipping container and its contents in the same condition as when
the damage was discovered insofar as possible and call the delivering carrier to arrange on
site inspection within 10 days of delivery.
2. Receiver should contact Aladdin Customer Service at 1-800-888-8018 for claims
processing after inspection has been completed.
VI. INSTALLATION
This product contains micro processor based componentry.
Potential voltages on the ground line or unstable electrical circuits may adversely affect the
operation of this equipment due to high frequency harmonics generated. Reliable grounding
practices prior to installation should be made to ensure line noise is minimized.
This equipment is to be installed only by a qualied electrician. Installation Instructions
may be obtained from the Aladdin Temp-Rite Technical Services Department toll free
at 1-800-888-5426.
The installer should verify the proper operation of the unit as described in the following sections.
ELECTRICAL CONNECTION
Refer to Section II Specications data or the equipment data plate (located on the side of
the unit) your local codes and the National Electrical Code to be sure the ACTIVATOR is
connected to the proper power source. A protected circuit of the correct voltage and amperage
must be available for the connection of the power cord.
! WARNING !
Each Activator is tted with a grounded power cord and must be connected to a properly grounded
receptacle. Each receptacle must be wired to a dedicated circuit protected by a circuit protection
device rated at not more than 20 amps. If the Activator is not grounded a signicant electrical
shock hazard will exist.
To prevent electrical shock hazard turn the main power switch to the OFF position (No LED) and
disconnect the Activator from the power source whenever performing service or maintenance
functions. Always turn the Activator OFF (No LED) and disconnect it from the power supply prior
to removing the rear vented access panel. It is necessary to do this to prevent electrical shock
while performing service.
To Next Page
Loading...