Alarm.Com ADC-VC826 User Manual

Indoor/Outdoor Dome (ADC-VC826) Installation Guide
Pre-setup checklist
• ADC-VC826 camera (included)
• AC power adapter (required for non-PoE connections)
• Broadband (Cable, DSL or Fiber Optic Internet connection with router
• A computer or mobile device with Internet access
• An Ethernet / Cat5 cable
• Login and Password for the Alarm.com account to which you will add the camera
Add the camera to an Alarm.com account:
Complete these steps prior to installing the camera in its final location:
1. Connect the camera to the router via an Ethernet cable.
2. If the Ethernet connection does not provide power, connect the camera to the optional AC power adapter (sold
separately) and plug the adapter into a non-switched outlet.
3. Wait 2 minutes for the camera to connect to the Internet.
4. Add the device by either selecting the account in MobileTech OR by using a web browser and entering the
following URL: www.alarm.com/addcamera
5. Select the camera from the video list or type in its MAC address to begin adding the camera. The camera’s MAC
address is located on the base of the camera.
6. Follow the on-screen instructions to finish adding the camera. You may configure camera settings from the
Customer Website.
You can now unplug the camera and install it in its final location using the included hardware.
https://answers.alarm.com/Installation_and_Troubleshooting/Video_Devices/Indoor%2F%2FOutdoor_Dome_(ADC-VC826)/Indoor%2F%2FOutdoor_Dome_(ADC-VC826)_Installation_Guide
Updated: Mon, 23 Apr 2018 23:19:48 GMT
1

Alarm.Com ADC-VC826 Specifications

General

Brand	Alarm.Com
Model	ADC-VC826
Category	Security Camera
Language	English

Summary

Add Camera to Alarm.com Account

Connect Camera to Router

Connect the camera to your router using an Ethernet cable before final installation.

Connect to AC Power

If needed, connect the camera to the AC power adapter and a non-switched outlet.

Wait for Internet Connection

Allow two minutes for the camera to establish an internet connection after powering on.

Add Device via Web or Mobile App

Add the camera via MobileTech or by navigating to www.alarm.com/addcamera in a browser.

Identify Camera MAC Address

Select the camera from the video list or enter its MAC address found on the camera base.

Complete On-Screen Setup

Follow the on-screen prompts to finish adding the camera and configure settings.

Troubleshooting Camera Issues

Power Cycle Camera

If connection issues occur, try power cycling the camera and reconnecting.

Perform Factory Reset

Reset the camera to factory defaults by disconnecting power, removing cover, and holding the reset button.