Do you have a question about the Alarm.Com ADC-V515 and is the answer not in the manual?
Brand | Alarm.Com |
---|---|
Model | ADC-V515 |
Category | Security Camera |
Language | English |
Bring camera near router, plug into an outlet that cannot be turned ON/OFF for initial setup.
Allow 2-3 minutes for the camera's LED light to begin flashing white.
Log into the app, tap menu, then 'Add Device', select 'Video Camera', and 'ADC-V515'.
Confirm camera is generating video feed and listed in the 'Video' section after setup.
Temporarily connect to a network resembling ADC-V515 (with MAC address) during app setup.
LED changes during installation; solid green indicates successful Wi-Fi connection.
Installation may take up to 15 minutes if firmware updates are available.
Navigate to the 'Video' section to view live feeds or review recorded clips.
Use full-screen video to play, adjust volume, speak via microphone, or mute audio.
Set up or modify rules by navigating to 'Video' > 'Gear Icon' > 'Recording Rules' > 'Add'.
Watch up to 29 days of 24/7 video footage from the mobile app using a compatible micro-SD card.
Search footage by event, date, or time, supplementing analytics that record snippets based on activity.
Solid Green indicates camera is connected to Wi-Fi; Solid Red means no internet connection.
Flashing Red indicates the camera is powering on.
Flashing White indicates pairing mode; enter by holding the back button until LED flashes white.
Alternating Red & Green indicates factory reset; enter by holding back button until LED alternates.
Factory reset restores default settings; camera may need re-adding to the system.
If connectivity issues occur, power cycle the camera by unplugging and replugging the power.
For ongoing problems, reset the camera to factory default; refer to page 6 for details.
Connect using WPS if router supports it; scan QR code for alternative setup instructions.
Access knowledge base via QR code, or contact support via the app or by calling 1-877-602-5276.