User manual
8AL91434ENABed01 66 /113
After configuring WLAN, it is always possible to restart the wizard:
• Restart the desk phone.
• Select the settings icon displayed at the bottom left of the screen during the boot (after a
few seconds).
• WLAN wizard: Start the WLAN wizard.
The new configuration will replace the old one.
3.2.3 Manual configuration without wizard
You can manually configure your desk phone to connect to the selected Wi-Fi access point (SSID) without
using the wizard. Before configuring your phone, you need to know the name and the network security
key (passphrases) of the Wi-Fi access point.
• To enable the WLAN, disconnect your desk phone from the Ethernet.
• Plug in the ALE-108 (see chapter: ALE-108 Wireless Module).
• Access to the administration menu of the desk phone.
• Network
o Wireless Network Config
o Wifi config: press repeatedly until you set the value: User only
o Validate.
o Wifi scanning
▪ Sort order: sort the result by power or name.
▪ Filter: apply a filter to the results.
• None: all scanned SSIDs are listed.
• Register: only SSIDs that are still registered are listed.
• Unregister: only already-registered SSIDs are listed.
• Autoconf: only auto-configured SSIDs are listed.
• 2.4 GHz only: only 2.4 GHz SSIDs are listed.
• 5 GHz only: only 5 GHz SSIDs are listed.
▪ Wi-Fi access points are listed (SSIDs) depending on the filter:
• The characters displayed before the SSID name represent the signal
strength: the higher the number of characters displayed (one to three), the
better the signal.
• The displayed character indicates whether the SSID is new (+), already
saved (#), defined in the configuration file (@) or currently in use (*).
▪ Select the SSID.
▪ Register
▪ Select to enter the network security key (passphrase).
▪ Validate.
▪ Validate.
▪ Check the connection by selecting: Check Check connection.
▪ Select this icon until you see the exit icon.
o Exit the administration menu and the phone will be automatically restarted.
• Your phone is using the configured wireless network.
To Next Page
Loading...