Alcatel-Lucent 7210 SAS - Page 118

Show Commands
Page 118 7210 SAS D, E OS Router Configuration Guide
associations — Appends information as to where the filter policy ID is applied to the detailed filter
policy ID output.
counters — Displays counter information for the specified filter ID. Note that egress counters count
the packets without Layer 2 encapsulation. Ingress counters count the packets with Layer 2
encapsulation.
type entry-type — Displays information on the specified filter ID for the specified entry-type only
Output Show Filter (no filter-id specified) — The following table describes the command output for
the command when no filter ID is specified.
Sample Output
A:ALA-49# show filter ip
===============================================================================
IP Filters
===============================================================================
Filter-Id Scope Applied Description
-------------------------------------------------------------------------------
1 Template Yes
3 Template Yes
6 Template Yes
10 Template No
11 Template No
-------------------------------------------------------------------------------
Num IP filters: 5
===============================================================================
A:ALA-49#
*A:Dut-C>config>filter# show filter ip
===============================================================================
IP Filters Total: 2
===============================================================================
Filter-Id Scope Applied Description
-------------------------------------------------------------------------------
10001 Template Yes
fSpec-1 Template Yes BGP FlowSpec filter for the Base router
-------------------------------------------------------------------------------
Num IP filters: 2
===============================================================================
Label Description
Filter Id
The IP filter ID
Scope
Template —
The filter policy is of type template.
Exclusive — The filter policy is of type exclusive.
Applied
No —
The filter policy ID has not been applied.
Yes — The filter policy ID is applied.
Description
The IP filter policy description.