Alcatel-Lucent 7210 SAS - Page 119

Filter Policies
7210 SAS D, E OS Router Configuration Guide Page 119
*A:Dut-C>config>filter#
Output Show Filter (with filter-id specified) — The following table describes the command output for
the command when a filter ID is specified.
Label Description
Filter Id
The IP filter policy ID.
Scope
Template —
The filter policy is of type template.
Exclusive — The filter policy is of type exclusive.
Entries
The number of entries configured in this filter ID.
Description
The IP filter policy description.
Applied
No —
The filter policy ID has not been applied.
Yes — The filter policy ID is applied.
Def. Action
Forward —
The default action for the filter ID for packets that do not
match the filter entries is to forward.
Drop — The default action for the filter ID for packets that do not
match the filter entries is to drop.
Filter Match
Criteria
IP —
Indicates the filter is an IP filter policy.
Entry
The filter ID filter entry ID. If the filter entry ID indicates the entry is
(Inactive), then the filter entry is incomplete as no action has been
specified.
ICMP Type
The ICMP type match criterion. Undefined indicates no ICMP type
specified.
Fragment
False —
Configures a match on all non-fragmented IP packets.
True — Configures a match on all fragmented IP packets.
Off — Fragments are not a matching criteria. All fragments and non-
fragments implicitly match.
TCP-syn
False —
Configures a match on packets with the SYN flag set to
false.
True — Configured a match on packets with the SYN flag set to true.
Off — The state of the TCP SYN flag is not considered as part of the
match criteria.
Match action
Default —
The filter does not have an explicit forward or drop
match action specified. If the filter entry ID indicates the entry is
Inactive, the filter entry is incomplete, no action was specified.
Drop — Drop packets matching the filter entry.