1.15.3 Pairing and connecting the Bluetooth® wireless handset
This feature is only available with compatible Bluetooth® deskphone. Otherwise the corresponding menu
is not displayed or is inactive.
Before the Bluetooth® handset can be used, it must be correctly paired to the terminal.
• Use one of the following:
o
o (long press) Bluetooth®
• Search devices
• With the handset turned off, press the 2 Bluetooth® handset keys at the same time (long
press).
You will hear a 3 note signal and the LED will flash green and orange alternately.
Searching for Bluetooth® equipment. Wait for the detected equipment type and address to be
displayed.
• Select the Bluetooth® wireless handset displayed in your deskphone: “IC Touch handset”.
• Add
• Enter the PIN code of the device if necessary.
• Confirm The 3-note tone indicates that the handset has been installed correctly. The LED
flashes green or orange depending on the battery charge level.
Error messages
• The Bluetooth® handset emits a sequence of 4 beeps: Your set is an older generation than your
Bluetooth® handset.
• The set displays an error message indicating that the set and the Bluetooth® handset are
incompatible: Your Bluetooth® handset is an older generation than your set.
1.16 Install a comfort wired handset
You can install a wired handset in place of the Bluetooth® Wireless Handset.
• Remove the rubber.
• Plug-in the wired handset to the appropriate connector
(refer to phone description).
• Make sure you position the cable correctly in the
compartment intended for that purpose:-:
• Switch off the Bluetooth® Wireless Handset (press and hold
the On/Off hook key until you hear distinct tones).
To Next Page
Loading...
