8232 DECT Handset
Maintenance Manual
8AL 90305 USAA ed02 6 /16
See "survey_doc_DECT_AGAPdm09011b0280086533.pdf" to explain additional lines of the site survey.
Note:
- Long press on * key: Slow/Rapid measurements
- Long press on # key: No Lock / Lock to base
Note :
This site survey mode is not appropriate for Dect installations due to lack of accuracy of quality index.
For Dect installations, please refer to “DECT and IP-DECT Engineering Rules and Site Survey Kit Manual
(8AL_90874_USAAed01)”
HS Logs
The HS log is a debugging feature that allows the user to retrieve low level interesting messages from
the handset.
Info: This information may be requested by Technical Support in case of site debugging
These are debug error logs retrieved from the PP log file. The last log
retrieved is formatted into:
Error: Log event error code. Valid value is 0000 to FFFF (in Hex).
Line: Location within the software code which triggered this error. Valid
value is 0000 to FFFF (in Hex).
Address: Register bank and/address from which error occurred. Valid value is
00000000 to FFFFFFFF (in Hex.)
Timestamp: Date and Time when the log error event occurred.
This reports of the function/exception handler that runs after an erroneous
state in handset operation.
Next assert ID: Immediate exception handler ID to be run when a specific
error occurs. Valid value is 00 to FF (in Hex).
Assert address: Register bank and/address where an exception handler is
executed as a result of the error which occurred. Valid value is 00000000 to
FFFFFFFF (in Hex.)
Screenshots
To Next Page
Loading...
