Alcatel-Lucent 8262Ex - Installing the Memory Card

8262/8262Ex DECT Handset
8AL90323ENABed01
14 /63
2.2 Installing the memory card
Never install the memory card in an ATEX (potentially explosive atmosphere) area.
The handset Micro SD card stores handset configuration data.
The Bluetooth settings are not saved on the Micro SD card.
If memory is removed, the handset will keep registration but the phone configuration and storage content
will revert to what they were before the memory card was inserted. If the memory card is placed in a new
8262 DECT Handset, the phone will use all user settings and storage content from the memory card but the
new phone must still be registered.
You must be in possession of the memory card for your phone.
The supported Micro SD memory cards are:
 Kingston 2, 4, 8 & 16 GB – Class 4 & 10.
 Transcend 2, 4, 8 & 16 GB – Class 4 & 10.
Switch off the handset (long press).
Remove the battery from the telephone. See chapter: Removing the battery from the telephone.
Slide in the memory card from under the two small crescents and press it
as shown in figure.
Place the battery on the telephone. See chapter: Installing the battery in the telephone.
Switch on the handset (long press).