8AL90323ENABed01
11 Declaration of compliance
This equipment uses DECT frequency range that depends on country: 1880 - 1900 Mhz in Europe, 1920 -
1930 MHz in US/Canada, 1910 - 1930 MHz in LATAM, 1910 - 1920 MHz in Brazil. The equivalent
isotropically radiated power at the antenna is less than 110 mW or 250 mW (it depends on the country).
This equipment offers also Bluetooth® Interface: frequency range 2402-2480 MHz, Radiated Power 1.72
mW.
EUROPE
This equipment is in compliance with the essential requirements of Radio Equipment Directive (RED)
2014/53/EU and with Directive 2011/65/UE (ROHS).
The Declaration of Conformity may be obtained from:
ALE International 32 avenue Kléber – 92700 Colombes, France
ebg_global_supportcenter@al-enterprise.com
USA and Canada
Handset: This device complies with Part 15 of the FCC Rules and with RSS of Industry Canada (FCC ID:
T7HCT8162 IC: 4979B-CT8162). This device complies with Part 68 of the FCC Rules and with IC CS-03
Part V of Industry Canada.
Chargers: This device complies with Part 15-B of the FCC Rules and with ICES-003 of Industry Canada.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Exposure to Radio Frequency Signals.
This device has been designed and manufactured not to exceed the SAR (Specific Absorption Rate) radio
frequency power transmission limits established by the different countries concerned. The SAR value
measured is equal to 0.089 W/kg (the globally accepted maximum limit being 1.6 W/kg).
User Instructions
Only use the handset in temperatures between -10°C to +55°C (14°F to 131°F). Only charge the battery at
temperatures between +5 °C and +40 °C (41 °F and 104 °F).
Acoustic shock protection
Maximum sound pressure level for handset is compliant with European, US and Australian standards.
Directive 2003/10/EC specifying the risks inherent in noise at work
The ring contributes towards overall daily noise. To reduce the level, the following is recommended: reduce
the setting, program a progressive ring.
Privacy
Privacy of communications may not be ensured when using the Bluetooth® handset or any additionnal
Bluetooth® device.
Disposal:
The equipment must be returned to a collection point for electronic equipment waste
disposal.
Defective batteries must be returned to a collection point for chemical waste disposal.
Related Documentation:
Other languages for these Safety and Regulatory Instructions and User Documentation are available at the
following Web site: http://enterprise.alcatel-lucent.com?product=All&page=Directory.
The information presented is subject to change without notice. ALE International assumes no responsibility
for inaccuracies contained herein. Copyright© ALE International 2016.
To Next Page
Loading...
