Alcatel-Lucent 9363 - Page 37

Connect the Ethernet cable
To attach the Ethernet cable perform the following steps.
...................................................................................................................................................................................................
1
Route the supplied Ethernet cable from the Metro Cell - Indoor to the Router/48V PoE+
injector.
Note: 48V PoE+ injector is not used when power is supplied via an external power
adaptor.
...................................................................................................................................................................................................
2
Plug one end of the Ethernet cable into the Ethernet connection port on the device.
Metro Cell - Indoor
DSL Router with
PoE+ function
Ethernet Cable
Total cable length 100m max
Metro Cell - Indoor
DSL Router with
PoE+ function
Ethernet Cable
Total cable length 100m max
PoE+ Power
Injector
Metro Cell installation and commissioning Metro Cell - Indoor cabling
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
Alcatel-Lucent 9363 MC
401-387-097
Issue 1 May 2011
Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
3-11