Alcatel-Lucent 9363 - Metro Cell - Indoor commissioning process

Metro Cell - Indoor commissioning process
Purpose
This section describes the 9363 Metro Cell - Indoor commissioning process. The 9363
Metro Cell - Indoor is self commissioning in the case of single device deployments.
Where multiple device deployments occur the operator may compliment zero-touch
commissioning with appropriate cell planning.
Troubleshooting
If any problems occur during the commissioning process refer to the following document:
• Alcatel -Lucent Metro Cell - Indoor and Outdoor Troubleshooting, 401-387-076.
Commissioning process
The following steps outline the zero-touch commissioning process.
...................................................................................................................................................................................................
1
Power on the 9363 Metro Cell - Indoor. After 1-3 seconds the power supply status
indicator will light up and the Ethernet port status indicator will flash green.
...................................................................................................................................................................................................
2
After approximately 2 minutes the 9363 Metro Cell - Indoor will initialize and establish
connectivity. During this operation the System status indicator will blink slowly.
...................................................................................................................................................................................................
3
After the device has established a network connection the 9363 Metro Cell - Indoor will
automatically update it's software. This process takes approximately 15 minutes. During
this operation both the System and Phone (device) indicators will blink.
...................................................................................................................................................................................................
4
Once the software update has completed the 9363 Metro Cell - Indoor will carry out an
automatic reboot. During reboot the Power and System indicators will be on.
...................................................................................................................................................................................................
5
After rebooting the device will automatically auto-configure itself. During this operation
the System status indicator will blink slowly.
...................................................................................................................................................................................................
6
When the device is ready for use the Power, System and Phone (device) status indicators
will all be ON.
Metro Cell installation and commissioning Metro Cell - Indoor commissioning process
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
3-14
Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
Alcatel-Lucent 9363 MC
401-387-097
Issue 1 May 2011
E ND OF STEPS
...................................................................................................................................................................................................