If Then the required initializa-
tion mode is
And
You use DHCP server Dynamic or Proprietary Dy-
namic
Refer to table: Initialization
procedure
You use another DHCP server Dynamic mode Refer to table: Initialization
procedure
You do not use a DHCP serv-
er
Static mode - Refer to table: Initialization
procedure
- Obtain from your network
administrator:
• An IP address for the
IP Touch set
• The subnetwork mask
• The router address
• The TFTP server ad-
dress, which is the IP
address of the Power-
CPU board embedding
the VoIP board
Note:
You need to know your set's
directory number.
Initializing the IP Touch set
To initialize the IP Touch set, refer to the table below.
table 4.29: Initialization procedure
For an initializa-
tion that is
Procedure
Dynamic Alcatel-
Lucent Enter-
prise mode
- If necessary, enable the DHCP server (in OMC, Hardware and Limits > LAN/IP
Configuration > DNS/DHCP)
- Connect the power supply.
- Before initialization phase 5 starts, press i, then the # key.
The Main menu appears.
- If the set was previously in static mode, select IP Parameters from the Main
menu.
The IP Parameters menu appears.
- Select Dynamic.
- Save by pressing the soft key in the upper left part of the display.
- Exit the Main menu by pressing the soft key in the upper right part of the display.
Dynamic mode 1. Connect the power supply.
2. Before initialization phase 5 starts, press i, then the # key.
The Main menu appears.
3. If the set was previously in static mode, choose IP Parameters from the Main
menu.
The IP Parameters menu appears.
4. Choose Dynamic.
5. Save by pressing the soft key in the upper left part of the display.
6. Exit the Main menu by pressing the soft key in the upper right part of the display.
Chapter
4
&'(
4-66
To Next Page
Loading...
Need help?
General
