Figure 4.41: 8082 My IC Phone set connectors
4.4.2.1.2 Commissioning the set
This section describes how to commission the set in the two available initialization options:
- Static initialization: commissioning is manual on the set and through OMC
- Dynamic initialization (DHCP): no commissioning is needed, 8082 My IC Phone sets are
fully plug & phone
Depending on the selected mode, the set commissioning is different.
For static initialization, the operation order is as follows:
1. Connect the set, refer to Connecting the set
2. Configure network parameters on the set, refer to Configuring network parameters for
static initialization
For dynamic initialization, the operation order is as follows:
1. Configure OmniPCX Office DHCP server, refer to Configuring OmniPCX Office DHCP
server , or configure an external DHCP server, refer to Configuring an external DHCP
server for dynamic initialization
Chapter
4
&'(
4-40
To Next Page
Loading...
Need help?
General
