8281
Troubleshooting ......
Before contacting the service centre, you are
advised to follow the instructions below:
•You are advised to fully charge ( ) the
battery for optimal operation.
•Avoid storing large amounts of data in your
phone as this may affect its performance.
•Use User Data Format and the Mobile Upgrade
tool to perform phone formatting or software
upgrading, (to reset User Data format, hold
down # while simultaneously pressing the
power on/off key under power off mode). ALL
User phone data: contacts, photos, messages
and files will be lost permanently.
and carry out the following checks:
My phone is frozen or cannot switch on
•Check the battery contacts, remove and
reinstall your battery, then turn your phone
on
•Check the battery power level, charge for at
least 20 minutes
•If it still does not work, please use User Data
Format to reset the phone or Mobile Upgrade
to upgrade software
My phone has not responded for several
minutes
•Restart your phone by pressing and holding
the key
•Remove the battery and re-insert it, then
restart the phone
•If it still does not work, please use User Data
Format to reset the phone or Mobile Upgrade
to upgrade software
My phone turns off by itself
•Check whether your phone is locked when not
in use, and make sure you don't accidentally turn
off your phone when locking it by pressing the
power key.
•Check the battery charge level
•If it still does not work, please use User Data
Format to reset the phone or Mobile Upgrade
to upgrade software
My phone cannot charge properly
•Make sure you are using an ALCATEL ONE
TOUCH battery and the charger from the box
•Make sure your battery is inserted properly
and clean the battery contact if it’s dirty.
It must be inserted before plugging in the
charger
•Make sure that your battery is not completely
discharged; if the battery power is empty for
a long time, it may take around 20 minutes
to display the battery charger indicator on
the screen.
•Make sure charging is carried out under
normal conditions (0°C to +40°C)
•When abroad, check that the voltage input is
compatible
My phone cannot connect to a network or
“No service” is displayed
•Try connecting in another location