27
If you are using charging unit 4071BC, charging information is displayed on your
terminal screen.
CChhaarrggiinngg
tthhee
tteerrmmiinnaall
Insert the terminal into the charger (1). This initiates a fast charge phase which lasts
around 90 minutes.
- If the terminal is fully discharged, it will be OFF. LED (2) lights up green, and then
changes to red.
- If the terminal is partially discharged, it may be OFF or ON. In this case, LED (2)
lights up red.
When the portable terminal is charged, the "trickle charge" phase is initiated. The LED
then goes green and the terminal may be used.
Note:
Do not remove the terminal from its charging point frequently or unnecessarily.
- When the terminal is inserted into the charging unit, the LED lights up red, indicating
the start of the charging phase.
- Charging is only possible between + 5°C and + 40°C, and is optimum between
+ 10°C and + 30°C.
- The first time the telephone is used, if, after charging for 5 minutes, the battery
symbols are not flashing on the screen, insert the battery only in the charger rear
housing and leave on charge for at least 2 hours (overnight is recommended).
To Next Page
Loading...
