51
CC OO MM FF OO RR TT
RReeppllyyiinngg
wwiitthhoouutt
lliiffttiinngg
tthhee
hhaannddsseett
((hhaannddss--ffrreeee))
FFoorr
tteerrmmiinnaallss
44007744
GGHH//GGII
This function is only available on terminals configured with the
""HHeeaaddsseett
ffuunnccttiioonn""
programmed key.
The headset can thus be used to receive calls without handling the terminal.
To activate the hands-free function, press the programmed key. An incoming call is
then indicated by a beep and the terminal automatically picks up the call.
The terminal goes back to idle a few seconds after the end of the call.
The hands-free function can be cancelled by pressing the same programmed key.
FFoorr
tteerrmmiinnaallss
44007744
GGCC
eeqquuiippppeedd
wwiitthh
cchhaarrggeerr
44007711
BBCC
This function can be activated in two ways:
- terminal on charge, lift the receiver and leave the telephone on the charger,
- terminal not charging, lift the receiver and place the handset on the charger.
To cancel the hands-free function, remove the handset from the charger.
Note: during a call in hands-free mode, the charging function is disabled. The terminal is thus
not being charged and hands-free mode is therefore not recommended when the terminal
charge level is low.