15 16
Installing or removing the battery
Insert and click the battery into place, then close the phone cover.•
Unclip the cover, then remove the battery.•
Installing and removing the memory card (MicroSD card)
To release the microSD card holder, slide it in the direction of the
arrow and lift it. Then insert the microSD card with the golden contact
downward. Finally, turn down the microSD holder and slide it in the
opposite direction to lock it.
Charging the battery
Connect the battery charger.
The • End key's backlight will be lit up when charging a completely flat
battery. After a while the light will go out and the phone can then be
switched on.
Be careful not to force the plug into the socket.•
Make sure the battery is correctly inserted before connecting the •
charger.
The mains socket must be near to the phone and easily accessible (avoid •
electric extension cables).
When using your telephone for the first time, charge the battery fully •
(approximately 4 hours).
You are advised to fully charge the battery (
).
To reduce power consumption and energy waste, when battery
is fully charged, disconnect your charger from the plug; switch off
Wi-Fi, GPS, Bluetooth or background-running applications when
not in use; reduce the backlight time, etc.
To Next Page
Loading...
Need help?
General
