AUS
1300 886 649
Basic cleaning
1. Remove the packaging material and all protective foils.
2. Clean all parts of the pressure cooker before first use as described in the chapter
“Cleaning and maintenance”.
Installing the condensation collector
Install the condensation collector
13
onto the side of the base unit
8
(see Fig. C).
It collects and holds the extra condensation during cooking.
Connecting to power
1. Insert the connector end of the power cord
14
into the power socket
12
of the
pressure cooker.
2. Connect the plug of the power cord to a wall socket.
A beep sound can be heard and “0000” can be seen on the display
25
once the
pressure cooker is powered. The pressure cooker is now in the standby mode and
ready for use.
Safety devices
The pressure cooker is equipped with the following safety devices for safe cooking.
Safety valve
The safety valve
1
checks the inside pressure of the pressure cooker. While pressure
is building up, the safety valve pops up and locks the lid
3
. When the safety valve
pops up, you should never attempt to open the lid of the pressure cooker.
When the safety valve has dropped back down to its original position, the pressure
cooker is no longer under pressure. The lid can then be opened.
Pressure regulator
Turning the pressure regulator
2
to the “steam release” position will release the
extra pressure in the pressure cooker for safe opening of the lid
3
when cooking is
done. Use a tool (e.g., a long wooden spoon) or protect your hands with oven mitts
to turn the pressure regulator. This will avoid getting your hand in contact with hot
steam which may cause injury.
To Next Page
Loading...