AUS
1300 886 649
Cleaning the base unit
− Use a soft damp cloth to clean the outer surface of the base unit
8
, heating
plate
9
, control panel
10
and handles
11
. Then let all parts dry completely.
Cleaning the pot
− Wash the pot
7
after each use in warm soapy water with a non-abrasive
sponge. Rinse and dry thoroughly. Replace it into the base unit after cleaning.
Cleaning the lid
− If the silicone sealing ring is not fitted correctly onto the lid, this
will prevent the lid from closing properly and stop the pressure
cooker from operating normally.
1. Carefully remove the silicone sealing ring
4
and steel plate
5
from the lid
3
by pulling on the metal peg
6
. Remove the silicone sealing ring from the steel
plate. Wash them in warm soapy water and then dry thoroughly.
2. Remove the pressure regulator
2
by pulling it up and off (see Fig. J). Rinse with
warm water and dry thoroughly before replacing it to the original position.
3. Remove the pressure regulator cover
29
by pulling it off (see Fig. K). Rinse with
warm water and dry thoroughly before replacing it to the original position.
4. Rinse the upper and underside of the lid in warm water and dry thoroughly. Rinse
the safety valve
1
and safety valve sealing ring
30
with running water.
5. Reassemble the silicone sealing ring onto the steel plate after cleaning. Push them
onto the centre post
31
on the underside of the lid. Make sure the metal peg on
the steel plate faces out (see Fig. L).
Cleaning the accessories
− Remove the condensation collector
13
from the base unit
8
and then empty
and wash it thoroughly. Let it dry completely and replace it back to the original
position.
− Clean the rice spatula
17
, measuring cup
16
and steaming rack
15
in soapy
water with a non-abrasive sponge. Rinse and dry them thoroughly.
Replacing the sealing rings
− The silicone sealing ring
4
, safety valve sealing ring
30
and silicone washer
32
are wearable parts and must be replaced if damage is found.
− Contact the manufacturer for replacement using the service address specified on
the warranty card.
To Next Page
Loading...