First use
22
5
28
5. Raise the presser foot lever
28
to raise the presser foot (see Fig. 5).
6
14
6. Hold the upper thread firmly and turn the handwheel
14
(anti-clockwise) to-
wards you (see Fig. 6).
The needle
2
dips into the bobbin compartment and when raised retrieves the
bobbin thread using a loop.
7
23
7. If this loop has been formed, pull on the upper thread slightly and retrieve the end
of the bobbin thread with a needle or scissors.
The bobbin thread should now be pulled through the small hole in the needle
plate
23
(see Fig. 7).
To Next Page
Loading...
