First use
20
Using the threader
1
2 5
1. Pass the wire loop of the threader
5
through the eye of the needle
2
from
right to left (see Fig. 1).
2. Insert the thread through the wire loop.
3. Pull the wire loop (with the thread) out through the eye of the needle.
4. Remove the thread from the wire loop.
Threading the bobbin thread
• Only use the bobbins supplied!
• The upper thread must be threaded before you thread the bobbin
thread.
1
22
1. Remove the cover of the bobbin compartment
22
by sliding it to the left (see Fig. 1).
To Next Page
Loading...
