ALDI Easy Home PAC2 - Airflow and Water Drainage

4. Use the MODE button
25
or the "MODE" remote control button to select an
operating mode.
The selected mode is shown by the mode indicator (COOL/DEHUM/FAN)
22
.
The timer starts to count down the remaining time and the product switches
itself on when the timer reaches zero.
5. To cancel the timer function, press the TIMER button
23
or the "TIMER" remote
control button
35
again.
Sleep timer
1. Press the TIMER button
23
or the "TIMER" remote control button
35
when the
device is switched on.
2. Use the TEMP- button
27
and the TEMP+ button
28
to set the timer (1–24
hours).
If using the remote control: use the "TEMP+" button
33
and the "TEMP-" button
37
to adjust the settings.
The time you have set will flash on the display.
3. Press the TIMER button or the "TIMER" remote control button again to confirm the
time.
If you do not confirm the time or make any further inputs, the timer function will
turn off after approx. 10 seconds.
4. Use the MODE button
25
or the "MODE" remote control button to select an
operating mode.
The selected mode is shown by the mode indicator (COOL/DEHUM/FAN)
22
.
The timer starts to count down the remaining time and the product switches
itself off when the timer reaches zero.
5. To cancel the timer function, press the TIMER button
23
or the "TIMER" remote
control button
35
again.
Setting the air flow
Set the air flow by aligning the horizontal fins
2
and the vertical fins
3
as
desired.
Draining the water tank
The integrated water tank fills with water in the following situations:
- At low room temperature and high humidity, the device may not be able to
evaporate the moisture quickly enough. In this case, water accumulates in the
water tank.
- When the device is in dehumidifier mode, it extracts moisture from the air. This
causes water to accumulate in the water tank.
Operation
18