ALDI FERREX 63349 - Operation; Water Sources & Starting and Stopping the Spray Gun; Using a Garden Hose and Tap (Garden Hose Adaptor Not Supplied)

AFTER SALES SUPPORT
(toll free)
20V Pressure Spray Gun
e-mail: info.aldi@positecgroup.com1300 889 028
MODEL No.: CHW18W.91 • 01/2021 • 63349
13
F2
F3
REMOVE
INSTALL
Water Sources & Starting and stopping the
Spray Gun (Fig. G1)
1. When you are close to the water source, like a
pool or pond, connect the 6m hose (11) to the
hose adapter (3) and put the end with the hose
lter (13) into the nearest water source.
2. If you are too far from the water source, collect
water in a bucket or convenient container
instead. Then connect the 6m hose (11) to the
hose adapter (3) and put the end with the hose
lter (13) into the container.
3. Hold the soft handle of the spray gun with
your hand rmly. Adjust the height of the
spray gun to make sure the height distance
between the hose adapter (3) and the water
source is less than 1.5m. A distance greater
than 1.5m may cause the spray gun to not
draw any water, or there may not be sucient
pressure. Make sure the hose is not knotted or
kinked during the operation (Fig G2).
Using a garden hose and tap (garden hose adaptor not supplied)
1. Remove the hose adapter (3) (Fig. E1 E2) (refer to instructions on page 12).
2. Attach your home garden hose with suitable connectors.
3. Hold the soft handle of the spray gun with your hand rmly.
4. Turn the tap on.
Operation
2
1
F1
Hose adapter
Water source
Max1.5m