20V Pressure Spray Gun
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
MODEL: №. CHW18W.91 • 01/2021 • 63349
(toll free)
14
Starting and Stopping
1. Before rst use: If using the 6m hose and alternate water source, remove
any air trapped in the 6m hose (11) by placing the power nozzle (6)
below waist level and attaching the extension lance (7).
2. Then start the spray gun by pressing the lock-o switch (1) and the on/
o switch lever (2). Depending on the water source, it may take up to 30
seconds for water to travel along the 6m hose (11) and begin spraying.
To stop the spray gun, release the on/o switch lever (2).
Watering (Fig H)
NOTE: It is recommended to use the shower mode for watering.
Cleaning (Fig I, J)
WARNING: Do not connect the spray gun to water supplies that
are dirty, rusty, muddy, or corrosive. (Including window
cleaning liquids, plant foods, or fertilizers etc.)
NOTE: Not recommended for use with salt water; immediately rinse with
fresh water for proper maintenance.
Residual risk
Even if you use the 20V Spray Gun properly per the instructions provided
and following all safety notes, there are always residual risks. The following
risk may occur:
- Accidental Starting: Always remove the battery pack from the spray gun
before carrying out any adjustment, servicing or maintenance. When
not in use, store the battery in a safe, dry, clean environment.
- Risk of uid injection: Do not direct the output of the spray gun at any
person, the operator, or any animals. Never place hands in front of
H I J
To Next Page
Loading...
