Safety warnings common for grinding, or abrasive
cutting-o operations:
a) This power tool is intended to function as a grinder or cut-o
tool. Read all safety warnings, instructions, illustrations and
specications provided with this power tool. Failure to follow all
instructions listed below may result in electric shock, re and/or serious
injury.
b) Operations such as sanding, wire brushing, polishing are not
recommended to be performed with this power tool. Operations for
which the power tool was not designed may create a hazard and cause
personal injury.
c) Do not use accessories which are not specically designed and
recommended by the tool manufacturer. Just because the accessory
can be attached to your power tool, it does not assure safe operation.
d) The rated speed of the accessory must be at least equal to the
maximum speed marked on the power tool. Accessories running faster
than their rated speed can break and y apart.
e) The outside diameter and the thickness of your accessory must
be within the capacity rating of your power tool. Incorrectly sized
accessories cannot be adequately guarded or controlled.
f) Threaded mounting of accessories must match the grinder spindle
thread. For accessories mounted by anges, the arbour hole of the
accessory must t the locating diameter of the ange. Accessories
that do not match the mounting hardware of the power tool will run out of
balance, vibrate excessively and may cause loss of control.
g) Do not use a damaged accessory. Before each use inspect the
accessory such as abrasive wheels for chips and cracks, backing
pad for cracks, tear or excess wear. If power tool or accessory is
dropped, inspect for damage or install an undamaged accessory.
After inspecting and installing an accessory, position yourself and
bystanders away from the plane of the rotating accessory and
run the power tool at maximum no-load speed for one minute.
Safety instructions for all operations
7
To Next Page
Loading...