16
MODEL No.: CGA18MA.9 • 01/2022 • 707085
AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
20 V Li-ion Mini Grinder
17
MODEL No.: CGA18MA.9 • 01/2022 • 707085
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
(toll free)
20 V Li-ion Mini Grinder
3. Cutting
WARNING: For cutting, always work with the
outer guard / protective guard (8).
When cutting, work with moderate feed,
adapted to the material being cut. Do not
exert pressure onto the cutting disc, tilt or
oscillate the machine.
Do not reduce the speed of running down cutting
discs by applying sideward pressure.
The machine must always work in an up-grinding
motion. Otherwise, the danger exists of it being
pushed uncontrolled out of the cut.
When cutting proles and square bar, it is best to start at the smallest cross
section. (See Fig. F)
NOTE: For cutting stone, concrete or tile, always use the diamond cutting
disc. For cutting metal, always use the metal cutting disc.
4. Rough grinding
WARNING: Never use a cutting disc for rough grinding applications.
This can cause bodily damage by using the mini grinder for wrong
applications.
WARNING: Do not switch the grinder on whilst the disc is in contact
with the workpiece. Allow the disc to reach
full speed before starting to grind.
Always position the guard so that as much of the
exposed disc as possible is pointing away from you.
Be prepared for a stream of sparks when the disc
touches the metal.
For best tool control, material removal and
minimum overloading, maintain an angle between
the disc and work surface of approximately 15°-30°
when grinding. Use caution when working into corners as contact with the
intersecting surface may cause the grinder to jump or twist.
When grinding is complete allow the workpiece to cool. (See Fig. G)
F.
G.
To Next Page
Loading...