ALDI FERREX 707085 - Product Contents and Intended Use; Pack Contents; Intended Use

Pack contents / parts
Congratulations on the purchase of your FERREX® 20 V Li-ion Mini Grinder.
When you open your packaging, rst remove all items and check there are
no parts damaged or missing. If you nd anything wrong, do not operate the
product until the parts have been replaced or the fault has been rectied.
Failure to do so could result in serious personal injury.
Intended use of the 20 V Li-ion Mini Grinder
NOTE: This product is for private domestic DIY use only.
It is not suitable for commercial, industrial or trade use.
Use the 20 V Li-ion Mini Grinder only for cutting, roughing and brushing
metal and stone materials without using water. For cutting metal, a special
protection guard for cutting (accessory) must be used.
This user manual contains important information on how to use the 20 V
Li-ion Mini Grinder. Read this user manual carefully, in particular the safety
instructions, before using the product. Failure to follow this user manual may
lead to severe injuries or product damage.
Keep this user manual for further reference.
IMPORTANT INFORMATION.
NOTE: First time users or inexperienced operators pay particular attention to
the operation of the 20 V Li-ion Mini Grinder, including details of starting and
stopping and correct use of the 20 V Li-ion Mini Grinder on pages 16-17, as
well as the maintenance instructions on page 18.
Contents of carton
2
1 x 20 V Li-Ion Mini Grinder skin
3 x Cutting discs (2pcs metal cutting
discs + 1pc diamond cutting disc)
1 x Grinding disc
1 x Outer guard / Protective guard
1 x Hex key (5 mm)
1 x Instruction manual
1 x Warranty card & Details