ALDI FERREX 707085 - Operating the Mini Grinder; Switching On and Off; Grip and Handling

16
MODEL No.: CGA18MA.9 • 01/2022 • 707085
AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
20 V Li-ion Mini Grinder
17
MODEL No.: CGA18MA.9 • 01/2022 • 707085
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
(toll free)
20 V Li-ion Mini Grinder
Operation
1. Switch on/o
- Switching on
Move the on/o switch (4) forward to the grinder head and press the front
part of the on/o switch (4) down until it latches. Then you can release the
on/o switch (4). The grinder is now locked on for continuous use. (See Fig.
D1)
- Switching o
Push down the back of the on/o switch (4) and move the on/o switch (4)
backwards to the rear of the tool to switch o. (See Fig. D2)
2. Hand grip area
Hold the mini grinder rmly when operating as shown in Fig. E.
D1. D2.
E.
Residual risk
Even if you use the 20 V Li-ion Mini Grinder properly per the instructions
provided and following all safety notes, there are always residual risks. The
following risk may occur:
- Accidental Starting: Always remove the battery pack from the tool
before carrying out any adjustment, servicing or maintenance. When
not in use, store the device in a safe, dry, clean environment.
Reduce residual risks by using the 20 V Li-ion Mini Grinder with care and
following all safety notes as well as other instructions.
WARNING: Before use, check whether your national regulations
restrict the use of the device.