ALDI FERREX 707085 - Mounting the Wheel Guard

12
MODEL No.: CGA18MA.9 • 01/2022 • 707085
AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
20 V Li-ion Mini Grinder
13
MODEL No.: CGA18MA.9 • 01/2022 • 707085
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
(toll free)
20 V Li-ion Mini Grinder
Assembly
WARNING: Before undertaking any maintenance, service, or
changing a disc on the grinder itself, remove the battery pack.
1. Mounting the wheel guard
WARNING: For work with grinding or cutting discs, the outer guard /
protective guard (8) must be mounted . Use the correct type of disc for
your application.
- Wheel guard for cutting
Fix the outer guard / protective guard (8) onto the inner guard / wheel guard
for grinding (7) until it engages. The wheel guard for grinding (7) and outer
guard / protective guard (8) assemble together and make up a wheel guard
for cutting. (See Fig. A1)
NOTE: Ensure the clip on each side of the outer guard / protective guard (8)
are latched onto the inner guard / wheel guard for grinding (7).
- Wheel guard for grinding
Simply remove the outer guard / protective guard (8). The grinder is ready to
be used for grinding. (See Fig. A2)
- Adjusting the wheel guard
Turn the inner guard / wheel guard for grinding (7) to the desired position
until it engages. No tool is required for this. (See Fig. A3)
A1. A2. A3.