14
MODEL No.: CGA18MA.9 • 01/2022 • 707085
AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
20 V Li-ion Mini Grinder
15
MODEL No.: CGA18MA.9 • 01/2022 • 707085
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
(toll free)
20 V Li-ion Mini Grinder
2. Assembling/Replacing the disc (grinding disc, metal
cutting disc or diamond cutting disc)
WARNING: Do not touch grinding and cutting discs before they
have cooled down.
The discs can become very hot while
working.
WARNING: Before undertaking any maintenance, service, or
changing a disc on the grinder itself, remove the battery pack.
- Removing a disc
1) Clean the spindle and all parts to be mounted.
2) Press and hold the spindle lock button (5) to lock
the spindle. You may need to rotate the spindle
using the provided hex key (9) if the spindle lock
button (5) cannot be pressed down fully.
3) Loosen the clamping bolt with washer (6) by
turning it anti-clockwise using the provided hex
key (9).
4) Remove the clamping bolt with washer (6) and
the disc. (See Fig. B1)
WARNING: Press the spindle lock button only when the grinder
spindle is at a standstill. Otherwise, the mini grinder may become
damaged.
- Fitting a disc
NOTE: When tting a disc for the rst time, follow
steps 2 - 4 above before applying the disc.
1) Place the disc on the tool spindle. Ensure it is
correctly located.
NOTE: When installing the grinding disc, make
sure that the convex surface (a) is facing up.
2) Insert the clamping bolt with washer (6) through
the centre of the disc and onto the spindle.
3) Press and hold the spindle lock button (5) to lock the spindle. You may
need to rotate the spindle using the provided hex key (9) if the spindle
lock button (5) cannot be pressed down fully.
4) Tighten the clamping bolt with washer (6) by turning it clockwise using
the provided hex key (9). Make sure that the cutting disc (10/11)/grinding
disc (12) is assembled rmly. (See Fig. B2)
1
2
B1.
B2.
To Next Page
Loading...