Preparation
19
CAUTION!
Risk of injury!
When flipping the clamping lever, the clamping mechanism
generates a large amount of spring force, which will snap the
clamping lever back and may injure you.
− Always completely flip the clamping lever by 180° or up to the
stop point before you let go of the clamping lever.
− Avoid having the clamping lever come into contact with other
objects when in an open state. Otherwise, it can easily spring
back.
− Make sure that your fingers are not clamped in while
mounting the tool.
The tool may only be mounted once the extractor line
15
has been secured. To
ensure the safety and quality of the work, only use undamaged fitted tools in good
condition.
The tool holder
8
of the multifunction tool enables you to mount the tool in
different positions using the quick-release mechanism. Make sure that the fitted tool
is only attached from the right side (see Fig. F).
1. Open the clamping lever
1
all the way by flipping it up to the stop point (see
Fig.C). If applicable, remove any fitted tool that is already mounted.
2. Place the desired tool
9
/
10
/
11
/
12
or
13
at the desired angle on the tool
holder
8
. When using the plunge-cut saw blade
9
and the scraper
13
, make
sure to insert the tools the right way around (see Fig.F).
3. Hold the clamping lever in the hand and carefully hold it back as far as it will go
against the locking bracket
2
.
4. Engage the locking bracket (see Fig.D) and close the clamping lever so that it
locks into place.
5. Ensure that the tool is securely fixed in place.
Placing the sanding sheet on the sanding plate/changing the sanding sheet
− Attach the desired sanding sheet
14
to the sanding plate
11
with the hook and
loop fastener. Make sure that the sanding sheet is not protruding. The sanding
sheet must be completely attached to the sanding plate with the hook and loop
fastener and must be smooth.
To ensure best dust extraction, make sure that the holes in the sanding sheet
correspond to the holes on the sanding plate.
To Next Page
Loading...
