Cleaning and maintenance
21
Scraping
For best results, the scraper
13
must be sharpened regularly.
− Work on a soft base (e.g. wood) at a flat angle and while applying minimal
contact pressure. Otherwise, the scraper could cut into the surface.
− Select a moderate to high oscillation rate for scraping.
Sanding
− Select a high oscillation rate for sanding.
Follow the instructions below for proper sanding:
− Move the multifunction tool parallel and circularly over the surface or alternately
in longitudinal and transverse directions.
− The material removal rate and sanding quality are primarily determined by
the selection of the sanding sheet
14
, the preselected oscillation rate and the
pressing force.
− Press the multifunction-tool evenly and not too hard against the workpiece.
Pressing too strongly does not increase performance.
− Only work with the tip or an edge of the sanding plate
11
to sand profiles and
fillets. The sanding sheet can heat up significantly when sanding individual
points. Reduce the oscillation rate and contact pressure and let the sanding sheet
cool off regularly.
− Do not use the multifunction tool with liquid polishing agents or abrasives.
− If only one corner is worn down, move the sanding sheet
14
by 120°.
Cleaning and maintenance
WARNING!
Risk of injury!
Accidentally starting the multifunction tool may result in severe
injury.
− Take the rechargeable battery out of the multifunction tool
before cleaning or performing any maintenance on the
multifunction tool.
To Next Page
Loading...
